If you are having a problem while restarting the system normally, boot into Safe Mode using the steps described above to use the troubleshooter.įYI: can’t get the Windows Troubleshooter to work? Read our post to see what you can do about that. To proceed with this solution, restart your computer and run the Windows Update troubleshooter via the Settings app. If any problems are identified, it will attempt to fix them automatically or suggest fixes that you can implement manually. It works by scanning the system for potential issues that may be preventing updates from installing successfully. This is a diagnostic state in Windows that starts the system with only minimal drivers and services. In some cases, issues with software or drivers installed in the system can cause the update to fail, resulting in the problem behind the error message.Īn easy way to isolate such issues is by booting into Safe Mode. Tip: you will need to access BIOS sometimes to fix a problem in Windows. In this case, restarting your computer can be an effective way to fix the problem, as it will remove the glitch and attempt to reset any temporarily misconfigured settings. Additionally, there might be misconfigured or corrupted system settings that are interfering with the update process, leading to the problem at hand. The “Undoing changes to your computer” loop can persist because of a temporary glitch in the system. If the message persists for a long time, proceed with the troubleshooting methods listed below. It is usually best to wait for at least an hour or two to see any progress. Therefore, we recommend waiting a while before taking any further steps. In some cases, the loop might disappear after a couple of minutes, but if the update was large, it can take longer for the process to finish. This process can take time to complete, depending on the size of the update and the speed of your computer. The “Undoing changes to your computer” error means that the system is attempting to revert changes that were made during a failed update. If the system successfully boots in a normal mode, turn on the update service: press Win R, enter services.msc, find “Windows Update” in the list and set the launch type “Manual” (this is the default value). Close the command prompt and click "Continue" to restart the computer (boot from the HDD, not from the Windows 10 boot drive). sc config wuauserv start = disabled (temporarily disable the automatic start of the update service). ren c: \ windows \ SoftwareDistribution SoftwareDistribution.old Use this letter in step 7 instead of C, if necessary). list vol (as a result of executing this command, look at the letter your system disk has, since at this stage it may not be C. After booting from the installation drive, on the second screen (after selecting a language) at the bottom left, click "System Restore", then select "Troubleshooting" - "Command line". Boot the computer from it, for this you can use the Boot Menu. You may have to create such a drive on another computer. You will need a Windows 10 recovery disk or installation flash drive (disk) with Windows 10 in the same bitness that is installed on your computer.
0 Comments
Leave a Reply. |